Table des Matières
Publicité
Putting into operation • Puesta en marcha
Mise en service • Colocação em funcionamento
H
O
2
18
english
Operational aspects:
• Overloading of the QWIK-PURE impairs
the separating efficiency, shortens the
filter service life and can lead to overflow-
ing.
• Only use OEKOSORB cartridge sets for
replacement. The approved cartridges
are identified on page 18.
Intended use:
The QWIK-PURE oil-water separator is
used for treating non-emulsified condensate
in compliance with the legal regulations.
Feed fluid:
Compressor condensate
Condensate/ambient temperature: 34
... 140 °F
Discharged fluid:
Cleaned condensate with mineral oil hy-
drocarbon content far below the statutory
limit (see above).
Will meet standard EPA regulations. Check
with your local POTW for requirements.
To Begin operation:
Step 1. Remove the lid by loosening the 4 screws
on lid top.
Step 2. Check the cartridge area, make sure the fac-
tory plastic bag has been removed.
Step 3. Re-install the lid with the 4 screws. Make sure
not to over tighten.
Step 4. MUST BE COMPLETED before introducing
compressed air condensate to unit. Pour water
into the unit from the top through the pressure
relief chamber area.
Step 5. Stop pouring the water (approx. 18 gallons)
when it starts to come out at the water outlet that is
located on the side of the unit.
Step 6. Wait approximately 5 mins so the cartridge
will adsorb some of water & add additional water
to the unit until you see water coming out of the
outlet again. Once this has been accomplished the
unit will be recharged and ready for full operation.
Step. 7 You know can introduce condensate into unit
via the multiple inlet adaptor located on the top lid.
The QWIK-PURE is ready for operation:
- Feed in condensate
Checking for leaks
• Inspect hoses and connections, tighten
screws where necessary or replace
parts.
• Container
Contact BEKO in the event of leak-
age.
QWIK-PURE 100
Publicité
Table des Matières
