DBI SALA FAST-Line 3900105 Manuel D'entretien page 5

3.2.8: While holding the lifeline firmly, insert the
drum locking tool into the hole where the set screw
was removed.
3.2.9: Line up the drum locking tool with the hole
in the internal drum. When correctly inserted, the
locking tool can be threaded into the SRL housing.
THE DRUM LOCKING TOOL MUST LINE UP WITH THE
HOLE IN THE DRUM SO THAT WHEN THE LIFELINE
IS RELEASED THE DRUM WILL NOT TURN.
TURN THE DRUM LOCKING TOOL INTO THE
HOUSING UNTIL THE TOOL CONTACTS THE
DRUM COVER (APPROXIMATELY FOUR TURNS
OF THE DRUM LOCKING TOOL).
3.2.10: With a 1/8 inch Allen wrench, turn the set
screw clockwise all the way in. Approximately 17
rotations will be needed. Initially, the set screw
will turn with little resistance. Stop turning the set
screw when resistance becomes noticeably greater.
Overtightening the set screw will damage the threads
in the housing.
3.2.11: Push lifeline out top of SRL. Using a 9/16
inch wrench or socket and a 3/8 inch wrench, remove
the lock nut from the end of the cable stud.
5