Sound; Audio Adjustments; Graphic Equalizer - Aiwa NSX-HMA56 Mode D'emploi

SOUND

AUDIO ADJUSTMENTS

VOLUME
Turn VOLUME on the main unit, or press VOL on the
remote control.
The volume level is displayed as a number from 0 to MAX (50).
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To change the left/right balance
Press MANUAL SELECT on the remote control. L/R is displayed
for 2 seconds. Press f DOWN or g UP on the remote control
within these 2 seconds.
• The DOLBY PRO LOGIC (page 18) front speakers level is also
changed.
BBE SYSTEM
The BBE system enhances the clarity of high-frequency sound.
It also enriches the Karaoke function to make your voice sound
clear and pleasant.
Press BBE.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press T-BASS.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
• When playing back a tape recorded with BBE, it is
recommended that BBE be set to off to avoid distorted high
frequency sound.
• Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is
originally emphasized. In this case, cancel the T-BASS system.

GRAPHIC EQUALIZER

This unit provides the following five different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
LATIN: Accented higher frequencies for latin music.
CLASSIC: Enriched sound with heavy bass and fine treble.
JAZZ: Accented lower frequencies for jazz-type music
Press GEQ repeatedly, or press GEQ once and turn MULTI
JOG within 4 seconds, to select one of the equalization
curves.
"GRAPHIC EQUALIZER" appears and the GEQ mode is
displayed cyclically as follows.
ROCK POP LATIN
GEQ OFF
(cancel)
* The GEQ mode can be displayed in reverse order if MULTI
JOG is used.
To display the current GEQ mode
Press GEQ. The current mode is displayed for 4 seconds.
To cancel the selected mode
Press GEQ repeatedly, or press GEQ once and turn MULTI JOG
within 4 seconds, to select "GEQ OFF".
"GRAPHIC EQUALIZER" disappears.
To select with the remote control
Press GEQ repeatedly. The GEQ mode is displayed cyclically as
above.
Using the headphones
Connect headphones to the PHONES jack with a standard stereo
1
plug (ø6.3 mm, / inch).
4
No sound is output from the speakers while the headphones are
plugged in.
Sound adjustment during recording
The output volume and tone (except BBE) of the speakers or
headphones are freely varied without affecting the recording.
En
JAZZ
CLASSIC
9
ENGLISH