Table des Matières
Publicité
Composants
A
1
1x
2
3
1x
4
Outillage requis
4 of 15
B
TEMPLATE FOR
5x WorkFit PD Accessory Mounting Holes
0.22" (5.5 mm)
WorkFit-B, LD
1.57"
1.57"
2.38"
1.56" (39.5 mm)
(40mm)
(40mm)
(60.5 mm)
7.91"
1x
(201 mm)
1x Ø 12 mm Through
2.38"
(60.5 mm)
Temporarily adhere Template to bottom
0.49" (12.5 mm)
of worksurface and drill holes as specified.
3.27"
1.30"
1.30"
(83 mm)
4.66"
Refer to installation instructions for
4x Ø 6.5 mm Through
(118 mm)
(33mm)
(33mm)
7.09"
attachment of the brake release.
(180 mm)
3.15"
(80 mm)
CENTER OF
3.15"
MOUNTING
3.54"
(80 mm)
3.90"
PLATE
(90 mm)
(99 mm)
1x Ø 3 mm x 10 mm Deep (Ø 1/8" x 3/8" Deep)
For NON-RECTANGULAR
work surfaces:
Place this mark
16x Ø 4 mm x 10 mm Deep (Ø 5/32" x 3/8" Deep)
18.9" (480mm)
from the back of
the worksurface
For RECTANGULAR
work surfaces:
Place this mark
13.15" (334mm)
1. Center this mark from side-to-side.
from the front of
the worksurface
2. For RECTANGULAR work surfaces:
4.06"
Place this mark 13.15" (334mm) from
(103 mm)
the FRONT of the worksurface.
3. For NON-RECTANGULAR work surfaces:
4.37"
Place this mark 18.9" (480mm) from the
(111 mm)
BACK of the worksurface.
3.94"
(100 mm)
FRONT OF
3.19"
2.24"
(81 mm)
WORKSURFACE
(57 mm)
6.14"
(156 mm)
777-24-040-G-00 rev.A 04/13
2x
16x
#12-14 x 5/8"
4x
ST3.9 x 16mm
1x
M2.9 x 7mm
M2.9 x 7mm
14mm
Ø 1/8" (3 mm)
Ø 5/32" (4 mm)
Ø 1/4" (6.5 mm)
Ø 15/32" (12 mm)
C
888-24-228-G-00 rev.C • 10/13
Publicité
Table des Matières
