Dantherm MCS MASTER BCB 19 Manuel D'utilisation Et De Maintenance page 8

►►6. CONTROL PANEL ERROR DIAGNOSTICS
ERROR
E1
1. Electronic equipment over-
heating
2. Defective electronic equip-
ment
3. Blocked or faulty motor
E2
1. Inadequate voltage (over-
voltage)
2. Faulty electrical connec-
tions
E3
1. Inadequate voltage (under-
voltage)
2. Faulty electrical connec-
tions
E4
1. Faulty electrical motor con-
nections
E7
1. Cooler blocked
F4
1. Communication problems
F6
1. Communication problems
►►7. TROUBLESHOOTING
FAULT
The display does 1. No power supply
not work
2. Defective equipment
There is no air 1. Air vent clogged
flow or it is very
low
2. Defective equipment
The device does 1. Defective equipment
not respond to
the commands
The device leaks 1. The drainage plug is loose
water 2. The drain is dirty and the
3. The tank leaks
4. The panel is dripping
CAUSE
CAUSE
drainage plug does not fully
close
SOLUTION
1. Disconnect the cooler from the electricity
mains for a few minutes
2. Contact the support centre
3. Contact the support centre
1a. Check your system is powered correctly
1b. Contact the support centre
2. Contact the support centre
1a. Check your system is powered correctly
1b. Contact the support centre
2. Contact the support centre
1a. Check your system is powered correctly
1b. Contact the support centre
1a. Turn the cooler off and on again
1b. Contact the support centre
1. Contact the support centre
1. Contact the support centre
1a. Make sure that the device is con-
nected to the power supply
1b. Contact a support centre
2. Contact a support centre
1a. Keep the cooler away from walls
that may obstruct the airflow
1b. Remove any objects from the air
vent
1c. Contact a support centre
2. Contact a support centre
1. Contact a support centre
1. Close the plug
2. Clean the drain and close the plug
3. Contact a support centre
4. Contact a support centre
SOLUTION
en