vivocare Smilky Mode D'emploi page 18

2. Power key
1.Connect to the power, the backlight is lit, LCD will flashes for 1
second, then all off into standby.
2. Press the "
works into default "Stimulation"mode (level 1, 100CPM), 2 minutes
later, the pump will convert to "Expression" mode automatically
(level 4)
3. In any working mode, if you press"
ing; the backlight and LCD screen will off, electromagnetically
operated valve will cut off after energizing for 0.5 second.
3. Beep tone
1. Every time when you press any key, the buzzer alerts with "beep".
2. When the battery power is low, the buzzer alerts with "beep-beep"
till power off.
4. LCD display
A. Start up the pump, "Suction" & "Speed" in LCD will light all the
time.
B. When pump works on "Stimulation" mode, "Stimulation" in LCD
will light while "Expression" will off. When pump works on "Expres-
sion" mode, "Expression" in LCD will light while"Stimulation" will
off.
C. In "Stimulation" mode, there are 9 levels to adjust the suction,
"Suction" in LCD shows the 9 grid. The speed is fixed at 100CPM
which can not be adjusted ("Speed" in LCD shows full in grid.)
D. In "Expression" mode, there are 9 levels to adjust the suction and
the speed together. "Suction" & "Speed" in LCD shows 9 grid.
Grid represents "Suction" and "Speed" respectively: dynamicly
display from bottom to up according to the selected grade.
18
" on control panel, the backlight is lit, the pump
" the pump will stop work-