Troubleshooting - Tangent Danmark Dab2go+ Mode D'emploi

Troubleshooting

Error
The device does not switch
on or turned off suddenly.
No Power
No Sound or lower sound
No signal or hiss in DAB/FM
mode.
Cannot connect with the
device via Bluetooth.
Alarm doesn't work.
Remedy
1. Check if the power adaptor is connected properly.
2. The device may malfunction when used in areas with strong
radio interference. The device will work properly again once
interference ceases.
3. The normal function of the product may be disturbed by
strong Electro-Magnetic Interference. If so, simply reset the
product to resume normal operation by following the
procedures specified on instruction manual. If failure persists,
try to use the product in other location.
1.Ensure that the power adaptor is plugged to the mains
socket securely.
2.Ensure that the battery has been charged. If battery power is
low, charge the device by connecting the power adaptor.
1.Turn on the sound as it may be muted.
2.Increase the volume.
3.For AUX IN mode, check if the audio cable is connected
properly and the volume of the audio source is set high
enough.
1. Check the antenna if properly installed or move the antenna
to other position. Try to adjust the length of antenna.
2.Move the device to other location.
1. The device is connected with other Bluetooth-enabled
device. Disconnect that device and then try again.
1.Switch on the alarm.
2. The volume may not be properly set, refer to the solutions
of "No sound or lower sound".
3. The source of alarm was set to a station without signal.
Change the source of alarm or refer to "No signal or hiss in
DAB/FM mode".