Dab+ Radio Operation - Tangent Danmark Dab2go+ Mode D'emploi

DAB+ Radio Operation

Caution: Before listening to the radio, ensure that the DAB/FM Antenna is correctly
connected and adjusted with proper length and direction.
The icon on the top right corner of the display shows the strength of the DAB/DAB+
signal detected by the device.
Scanning to DAB+ stations
Auto scanning: Press SCAN button to run full scan of all stations. Alternatively, press
and hold MENU button to go to system menu where you can select SCAN to run same
operation. All stations are put on the Station List after scanning.
Station List:
Press MENU button to go to system menu, then select Station List to view the list of
stations already scanned. Rotate < TUNING /SELECT> control to select the station you
want to listen and press < TUNING /SELECT> control to confirm.
Manual Tune:
If the device could not receive the DAB+ station you want, rotate < TUNING /SELECT>
control to select station frequency manually. Once selected, press < TUNING /SELECT>
control to confirm and the staton frequency will be put on the station list.
Prune Invaild: Enter to remove the stations that are listed but not available. Press and
hold MENU button to go to system menu. Rotate < TUNING /SELECT> control to select
Prune Invalid and then choose Yes. Press < TUNING /SELECT> control to confirm.
DRC: If you are listening to music with a high dynamic range in a noisy environment, you
may wish to compress the audio dynamic range. This make quiet sounds louder, and
loud sounds quieter. Rotate < TUNING /SELECT> control to select DRC (high/low/off)
and press < TUNING /SELECT> control to confirm.
Station Order: The stations are listed by Alphanumeric/Ensemble/Valid. Rotate