GE GTR10HAX Manuel D'utilisation Et D'installation page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REVERSING THE DOOR SWING
2
REMOVE THE FRESH FOOD DOOR
Tape the door shut with masking tape.
Remove the center hinge and shim by removing
the screws (some models have lock washers with
each screw). Lift up the hinge to remove it.
NOTE: Some models have a washer between
the center hinge and the top of the fresh food door.
Do not lose.
Remove the tape holding the door shut.
Lift the fresh food door up and off the bottom hinge.
Set the door outside-up on a non-scratching surface.
NOTE: When removing the door, watch for washer(s)
between the bottom hinge and the bottom of the fresh
food door that may stick to the door. Do not lose.
CAUTION:
to the floor. To do so could damage the door stop.
Installation Instructions
Do not let door drop
(CONT.)
3
TRANSFER TOP HINGE TO
THE LEFT
Using a putty knife with the edge covered with
masking tape, remove the plug buttons. Be careful
of the paint finish.
Reinstall the plug button on the right side by inserting
it into the holes vacated by the top hinge screws.
Reassemble the top hinge and shim on the left side,
turning the screws just enough to hold the hinge
in place.
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gtr12haxGtr12hbx

Table des Matières