Hilti DX 6-GR Notice D'utilisation page 16

Safety-related instructions for use
Illustration showing
example
6.1 Loading the single-fastener tool
1. Push the fastener into the fastener guide from the front until the washer of the fastener is held in place in
the fastener guide.
2. Push the cartridge strip, narrow end first, into the grip of the fastening tool from below until the full length
of the cartridge strip is inside the fastening tool.
To use a cartridge strip in which some cartridges have already been used:
Pull the fully inserted cartridge strip by hand up and out of the fastening tool until the first unused
cartridge is in position in the cartridge chamber
6.2 Setting driving energy
Select the energy setting that suits the application. If no empirical values are available, always start with the
minimum driving energy.
1. Press and hold down the release button for the selector ring for driving energy.
2. Turn the selector ring for driving energy to the desired energy level.
Energy levels:
• 1 = lowest energy
• 8 = highest energy
3. Check whether the fastener was correctly driven in accordance with the operating instructions of the
fastener.
6.3 Driving fasteners
1. Position the fastening tool.
2. Hold the fastening tool perpendicular to the working surface and then press it at right angles against the
surface.
3. Press the trigger to drive the fastener.
6.4 Unloading the single-fastener tool
1. Pull the cartridge strip up and out of the fastening tool.
2. Pull the fastener out of the fastening tool.
6.5 Driving X-FCM grating fasteners
1. Drive the threaded stud into the steel beam.
Use the centering sleeve to help ensure easy centering of the fastener.
2. Position the X-FCM retaining flange.
3. Follow the instructions in the installation instructions of the fastener.
8 English
Description
Do not press the nosepiece of the fastening tool against any part of the
body!
Pressing the nosepiece against a part of the body (a hand, for example) can
make the fastening tool ready to fire. As a result, there would be the risk of a
fastener being fired into a part of the body.
4
5
6
12
2253454
*2253454*