Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Focus 31938000 Mode D'emploi / Instructions De Montage

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pres-
sures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• There must be an access door for maintenace.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
Technical Data
This mixer series-produced with EcoSmart
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
• The product is exclusively designed for drinking water!
• Safety against backflow
Fault
Insufficient water
Mixer stiff
Mixer dripping
Hot water temperature too low
Instantaneous heater didn't work
®
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
Cause
- check valve hasn't moved back
- Shower filter seal dirty
- filter insert shower dirty
- Cartridge defective, calcified
- Cartridge defective
- Hot water limiter incorrectly set
- Flow limiter in handshower isn't removed
- Shower filter seal dirty
- check valve hasn't moved back
Assembly (see page 6)
English
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 9)
To adjust the hot water limiter. Using a hot
water limiter in combination with a continu-
ous flow water heater is not recommended.
Dimensions (see page 5)
Flow diagram (see page 5)


Spare parts (see page )
Operation (see page 8)
Hansgrohe recommends not to use as drink-
ing water the first half liter of water drawn
in the morning or after a prolonged period
of non-use.
Maintenance (see page 11)
The check valves must be checked regularly
according to DIN EN 1717 in accordance
with national or regional regulations (at least
once a year).
Cleaning (see page 12)
Test certificate (see page 12)
with EcoSmart
®
without EcoSmart
®
Remedy
- Exchange check valves
- Clean filter seal between
shower and hose
- Clean filter insert between
shower and hose
- Exchange cartridge
- Exchange cartridge
- Set hot water limiter
- Remove flow limiter
- Clean filter seal between
shower and hose
- Exchange check valves