Specifications - INFOSEC UPS SYSTEM G1 Solar MPPT Manuel Utilisateur

SPECIFICATIONS

Table 1 Line Mode Specifications
Input Voltage Waveform
Nominal Input Voltage
Low Loss Voltage
Low Loss Return Voltage
High Loss Voltage
High Loss Return Voltage
Max AC Input Voltage
Nominal Input Frequency
Low Loss Frequency
Low Loss Return Frequency
High Loss Frequency
High Loss Return Frequency
Output Short Circuit Protection
Efficiency (Line Mode)
Transfer Time
Output power derating:
When AC input voltage drops to 95V or
170V depending on models, the output
power will be derated.
*Transfer time may be longer than specified figure when the unit is operating in parallel system.
Table 2 Inverter Mode Specifications
Rated Output Power
Output Voltage Waveform
Output Voltage Regulation
Output Frequency
Peak Efficiency
Overload Protection
Surge Capacity
Nominal DC Input Voltage
Cold Start Voltage
Low DC Warning Voltage
@ load < 20%
@ 20% ≤ load < 50%
@ load ≥ 50%
29
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 08 17 AA 59 201 05
Sinusoidal (utility or generator)
230Vac
170Vac±7V (UPS)
90Vac±7V (Appliances)
180Vac±7V (UPS);
100Vac±7V (Appliances)
280Vac±7V
270Vac±7V
300Vac
50Hz / 60Hz (Auto detection)
40±1Hz
42±1Hz
65±1Hz
63±1Hz
Line mode: Circuit Breaker
Battery mode: Electronic Circuits
>95% ( Rated R load, battery full charged )
10ms typical (UPS);
20ms typical (Appliances)
Output Power
Rated Power
50%
Power
90V 170V
5KVA/5KW
Pure Sine Wave
220Vac±5%
60Hz or 50Hz
90%
5s@≥150% load; 10s@110%~150% load
2* rated power for 5 seconds
48Vdc
46.0Vdc
44.0Vdc
42.8Vdc
40.4Vdc
280V
Input Voltage