HumanTechnik lisa DS-2/RG Mode D'emploi page 11

We would like to congratulate you on
purchasing the »lisa DS-2/RF«. You
have chosen a modern and reliable
system. Kindly read the instruction
manual carefully in order to use the
device properly and to familiarise
yourself with all the possibilities of the
system.
Package contents
Kindly check if all following parts are
included:
- »lisa DS-2/RF«
- 12 volts power supply unit
- Instruction manual
- Warranty card
Should any parts be missing, kindly
contact your specialist dealer or the
manufacturer directly.
Functioning principle
The »lisa DS-2/RF« is an electronic
clock with a digital time display. It
wakes you up with an acoustic signal
which is adjustable in pitch and volu-
me. It is also a complete lisa receiver,
capable of displaying the signals of
all lisa transmitters. A received signal
is displayed with flash and/or sound
and identified by 6 indicator LEDs.
The following accessories can be
connected to the »AUX« connector of
the alarm clock:
- Vibrating pillow
- Flash module
- Switch module
- Acoustic module
A-3303-0
A-3320-0
A-3330-0
A-3340-0
Setup
Connect the power supply unit to the
12 V power socket of the alarm clock
and plug it into a 230 V power outlet.
Setting the time
To set the time, press the time set
button » « for one second. The
hour digits will start to flash. Set the
desired hour by turning the adjusting
wheel (on the reverse side of the of
the clock) to the left or right.
Press the time set button »
The minute digits will start to flash.
Turn the adjusting wheel to the left or
right to set the desired minutes.
Pressing the time set button »
again will end the time setting proce-
dure and the set time is displayed.
Setting the alarm time
To set the alarm time, press the alarm
time button »
hour digits of the alarm time will start
to flash. Set the desired hour by tur-
ning the adjusting wheel to the left or
right.
Press the alarm time button »
The minute digits of the alarm time will
start to flash. Turn the adjusting wheel
to the left or right to set the desired
minutes.
Pressing the alarm time button »
again will end the alarm time setting
procedure and the set alarm time is
displayed.
« again.
« for one second. The
« again.
English 11
«
«