Compressors; Before First Use; Contents Of Packing; Intended Use - Batavia MAXXPACK 18 V Mode D'emploi

English

3. Before first use

Remove the machine and the accessories
from the packaging. Check the machine for
transport damage and do not use the
machine in case of damages. Keep the
packing materials away from children, risk
of suffocation!

4. Contents of packing

1× Cordless air compressor
1× Ball adapter
1× Airbed adapter
1× Tire valve adapter
1× Operating instructions

5. Intended use

The compressor is intended for filling bicy-
cle and motor vehicle tires and for inflating
toys, floats, balls and the likes. Additionally,
the compressor can be used to deflate toys,
floats, inflatable pools and the likes. The
compressor is not intended for filling lorry
or tractor tires. It is intended for domestic
used and not continuous commercial
operation.

6. ON/OFF switch

Set the main switch (2) to the "I" position to
turn on the low-pressure pump or the "II"
position to turn on the high pressure pump.
Set the main switch to the "O" or centre
position to turn off the compressor.

7. Operation of the high and low

pressure hoses

The compressor is equipped with a
high-pressure hose (6) and a low-pressure
hose (3). The high-pressure hose is for
inflating high pressure items like tires and
sports balls. The low-pressure hose is
designed for inflating or deflating low pres-
sure, high volume items like air rafts, mat-
tresses, and beach balls.
Note: Pressure gauge display and pre-set
features are used only in high pressure hose
applications.
6

8. Inflating with the high pressure

hose

The air chuck on the high pressure hose (6)
can be used without adaptor to inflate
motor vehicle tyres or with any application
that has a valve stem that fits the air chuck
opening.
Note: When inflating items of 1.0 PSI or
less, inflate in short bursts and check after
each burst by feel or with a calibrated meas-
uring device to determine accurate
pressure.
• Set the desired target pressure.
• Clamp the end of the air chuck down
onto the valve stem by pressing air
chuck clamp down until it stops or is
parallel with the high pressure air hose.
Note: The pressure readout on the gauge
while inflating ls a measurement of the
fluctuating pressure between the item and
the high pressure hose. To get an accurate
reading, stop inflating and follow above
instructions for reading the air pressure.
• Set the main switch (2) to "II" to start
inflating.
• The compressor will run until the target
pressure is slightly exceeded, then it will
decrease the pressure to reach the
target pressure.
• When the desired pressure is reached
and the compressor has stopped set
the main switch to "O".
• Remove the hose and store in hose
wrap on the right side of the
compressor.
• Turn off the display by pressing and
holding the (+) and (-) buttons until the
display turns off.
Note: Stand half a metre away from item
being inflated.