Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
6 NORMAL PLAYBACK
(1) Setting the Top Priority Playback Layer for
Super Audio CDs
2 The layer for top priority playback after the disc is loaded can be
set.
The layer set for top priority playback upon shipment from the
factory (default setting) is the Super Audio CD (stereo) layer.
1
3
1. Press the POWER switch to turn on the power.
2. Check that no disc is loaded.
If the layer is switched while the disc is being loaded, the
playback layer switches for that disc, but the top priority
playback layer setting itself does not change.
3. Press the SUPER AUDIO CD SETUP button and switch to the layer
you want to set.
When a disc is loaded after the setting has been made, the
contents recorded on the set layer are displayed.
If a disc that does not contain the layer set for top priority playback
is loaded, the contents recorded on another layer are displayed
automatically.
This setting is stored in the memory and is not cleared even when
the disc holder is opened or closed or the power is turned off. To
change the setting, repeat the procedure above.
(2) Starting Playback
1
5
4
1. Press the POWER switch to turn on the power.
2. Press the
button.
5
• The disc holder opens.
3. Load the disc you want to play.
For instructions on loading discs, refer to "OPENING AND
CLOSING THE DISC HOLDER AND LOADING DISCS". (See
page 11.)
4. Set the MODE knob to "NORMAL".
5. For Super Audio CDs, use the SUPER AUDIO CD SETUP button to
set the layer to be played, as necessary.
To check the currently playing layer, press the SUPER AUDIO
CD SETUP button once. "STEREO", "PCM CONV." or "CD" is
displayed. Press the button again while one of these is displayed
to switch the layer to be played.
6. Press the
/
button.
1
3
• Playback starts.
• Playback stops automatically after the last track on the disc has
been played.
(3) Stopping Playback
1. During playback, press the
• Playback stops.
12
3
2
6
1
button.
2
Publicité
Chapitres
Table des Matières
