Setting The Discharge Current; Saving The Settings; Starting A Charge/Discharge Process - Multiplex Power Peak Quad EQ-BID 230V Notice D'utilisation

Power Peak® Quad EQ-BID 230 V

SETTING THE DISCHARGE CURRENT

ted in steps of 0.1 A. Press the 'ENTER' button again to confirm your selection. The
discharge current up to 1A can be selected in steps of 0.1 A. The maximum discharge
current is dependent on the cell count as well as the battery voltage. The processor in the
battery charger will limit the maximum discharge current.
SETTING THE AUDIBLE SIGNAL
Press the 'INC/ DEC ' button to leaf through the screen display until the arrow is next to
There are 5 signal styles to choose from, also the acoustic signal may be switched off.
Each press of the "INC" or "DEC" button will set up a new signal sound and sound once
again to make the choice easier.

SAVING THE SETTINGS

Press the 'INC/ DEC ' button to leaf through the screen display until the arrow is next to
7.4

STARTING A CHARGE/DISCHARGE PROCESS

Prepare the memory for storage.
Operating Instructions
Press the 'INC/ DEC ' button to leaf through the
screen display until the arrow is next to Discharge
Current . Press the 'ENTER' button and the '+ / -'
symbol flashes. The charging current can be selec-
Charge Current. Press the 'ENTER' button and the
'+ / -' symbol flashes. Now use the "INC/ DEC" but-
tons to select the sound, e.g. the acoustic signal that
will sound when the charge process is complete.
End. The settings are saved by pressing the ENTER
button. The Display shows the start display again, it
returns to its initial home position.
the desired process
displays the stored parameters again.
process, an acoustic signal indicates the
status. Then the working display,
containing all important parameters,
is then shown (see Section 5.1).
the current during the charging procedure, the new
value flashes before being adopted.
15
39
# 30 8196