Menu Structure In Automatic Mode; Settings In Automatic Mode - Multiplex Power Peak Quad EQ-BID 230V Notice D'utilisation

Power Peak® Quad EQ-BID 230 V
6.1 Menu Structure for Automatic Mode (only NC and NiMH)
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
6.2

SETTINGS IN AUTOMATIC MODE

The battery charger automatically sets the charging/discharging current and the number of
cells in automatic mode. This mode is only available for NC and NiMH battery packs. The
types of battery are selected with the MODE button.
With the battery connected, the required operation is initiated by pressing the START but-
ton. Accompanied by an acoustic signal, the display changes over to the working display
(see Section 5.2, Page 8). The top line shows the process - Charge (C) or Discharge (D)
- and the charged-in or discharged capacity. Also, the time elapsed since the start of the
process is displayed. The bottom line shows the battery type, the current battery voltage
and the charge current. The current display alternates with the word 'auto' to indicate that
the charger is in automatic mode.
mode is then shown again. When the process is complete, the achieved final values are
Operating Instructions
'START'-
button
'START'-
Button
'START'-
Button
'START'-
Button
'START'-
Button
'START'-
Button
10
34
# 30 8196