Spektrum AR6400 Guide De L'utilisateur page 9

Transmitter Specific Binding Instructions
DX5e:
1. To bind your AR6400/AR6400L to the DX5e, plug the battery into the receiver. The LED
on the receiver will begin flashing.
2. Move the sticks and switches on the transmitter to the desired failsafe positions (low
throttle and neutral control positions).
3. Pull and hold the Trainer Switch on the transmitter while turning the transmitter on.
Release the trainer switch once the LEDs on the front of the transmitter flash.
4. The LED on the receiver will go solid and the system will connect after several
seconds.
DX6i:
1. To bind your AR6400/AR6400L to the DX6i, plug the battery into the receiver. The LED
on the receiver will begin flashing.
2. Move the sticks and switches on the transmitter to the desired failsafe positions (low
throttle and neutral control positions).
3. Pull and hold the Trainer Switch on the transmitter while turning the transmitter on.
Release the trainer switch once the word BIND flashes on the LCD screen on the front
of the transmitter.
4. The LED on the receiver will go solid and the system will connect after several
seconds.
DX7 (includes DX7se):
1. To bind your AR6400/AR6400L to the DX7, plug the battery into the receiver. The LED
on the receiver will begin flashing.
2. Move the sticks and switches on the transmitter to the desired failsafe positions (low
throttle and neutral control positions).
3. Press the bind button on the back of the transmitter while turning the transmitter on.
The bind button on the back of the transmitter will flash.
Release the button after 2-3 seconds.
4. The LED on the receiver will go solid and the system will connect after several
seconds.
EN