Spektrum AR6400 Guide De L'utilisateur page 8

EN
To safely accomplish advanced programming feature changes, please enlist the use of a helper. One to
hold the aircraft to prevent unintended flyaways, and one to make the changes on the transmitter.
Sticks must be held in this position while the transmitter is on and the receiver is off.
1. Ensure a successful bind was completed
2. Plug the X-Port accessory or the optional servo into the X-Port/CH5
3. Turn the transmitter on
4. Move the THRO stick to the full throttle position
5. Move Control sticks to the corresponding position to change between the available options. (see
illustration)
6. While holding this position, plug the battery into the receiver; power receiver
7. The LED on the receiver will go solid and within 5 seconds the LED will flash 3 times quickly,
indicating the option is now changed
8. Disconnect battery from receiver
9. Turn transmitter off
Mode 2
THRO/RUDD
Optional Support Items
PKZ3502 Propeller with Spinner: Sukhoi (160mm x 70mm)
PKZ3516 Motor: Sukhoi (8.5mm diameter, 20mm length)
PKZ3527 Gearbox without Motor: Sukhoi (Gear ratio 4:1)
PKZ3528
Propeller Shaft: Sukhoi
PKZ3302 Propeller with Spinner: Vapor (140mm x 45mm)
PKZ3316 Main Motor: Vapor (6.0mm diameter, 15mm length)
PKZ3327 Gearbox without Motor: Vapor (Gear ratio 6:1)
PKZ3328 Propeller Shaft with Gear (2): Vapor
PKZ1034 110mAh 1S 3.7V LiPo: Sukhoi
PKZ3001 3.7V 70mAh LiPo Battery: Cessna 210, Citabria, Ember/2, Vapor
EFLB1101S 110mAh 1S 3.7V LiPo: Blade mCX
EFLC1003 1S 3.7V LiPo Charger, 0.3A: Blade mCX
EFLC1004 E-flite Celectra 4-Port Charger for 1C 3.7V LiPo Battery Packs
PKZ3240 DC 3.7V LiPo Charger
EFL9051 Prop with Spinner (2): Ultra-Micro 4-Site
EFL9052 Main Motor: Ultra-Micro 4-Site
EFL9053 Gearbox with Motor Shaft: Ultra-Micro 4-Site
EFL9054 Prop Shaft with Gear (2): Ultra-Micro 4-Site
EFLB1501S 1S 3.7V 150mAh LiPo Battery
EFLB1201S 1S 3.7V 120mAh LiPo Battery
CH5/X-port
1. Full THRO
2. Right RUDD
ELEV/AILE
Mode 1
ELEV/RUDD THRO/AILE