Spektrum AR6400 Guide De L'utilisateur page 5

5. If you entered bind mode correctly, you will see a solid LED within about 10 seconds. You should
now be bound to the transmitter and have full control and function.
IMPORTANT: After Binding
Once the system is bound, the transmitter should always be turned on first and then the receiver to
prevent the receiver from re-entering bind mode. If your receiver inadvertently enters bind mode,
simply unplug the battery from the receiver and reinstall with the transmitter remaining on.
Advanced Programming Features
The following programming features are only recommended for advanced radio users. To safely accomplish
advanced programming feature changes, please enlist the use of a helper. One to hold the aircraft to prevent
unintended flyaways, and one to make the changes on the transmitter. The photos in this section show the
E-flite MLP4DSM transmitter, however, the procedures apply to all compatible transmitters.
Prior to making any advanced programming feature changes it is necessary to:
Computer Radios like the DX6i, DX7
1. Choose an empty model location
2. Select model type ACRO
3. Perform a model reset
4. Set all channels to normal reversing
5. Ensure a successful bind has been established
Note: Please secure the aircraft safely to a work bench or enlist the use of a helper while accessing the
advanced programming features. Mistakes in programming could cause the motor to run unexpectedly.
LP5DSM, HP6DSM
If you decide to use an E-flite LP5DSM or HP6DSM transmitter, please position your channel reversal dip
switches as follows:
LP5DSM Transmitter
Note: Keep a record of the existing settings in case you want to go back and fly your other aircraft.
Reversing Servos
Servo reversing may be achieved using the servo reversing function of your transmitter, or as
certain advanced applications require it, you may reverse the actual servos by following the
instructions and diagrams below.
Reversing The Servos on the Receiver Board
This feature reverses the servos at the board level, making it useful for implementing features such as
elevons while using transmitters with limited programming options.
Note: All changes made in advanced programming must start with the receiver powered down to
prevent the motor from running unexpectedly.
LED
HP6DSM Transmitter
EN