Electrical Safety - Elem Garden Technic LTDE1032-19 Traduction Des Instructions D'origine

Power supply
The voltage indicated on the
rating plate must correspond to
the voltage of the power source.
We recommend that this
equipment is only connected into
a socket which is protected by a
circuit-breaker that would be
actuated by a 30 mA residual
current.
Only use or replace power
supply cables for this unit which
correspond to the types indicated
by the manufacturer.
See the operating instructions for
the order no. and types.
Never touch the mains plug
with wet hands.
Do not run over, crush or pull
the power supply cable or
extension lead, otherwise it may
be damaged. Protect the cable
from heat, oil and sharp edges.
WARNING:
Packaging materials
are not toys! Children
must not play with
plastic bags! Danger
of suffocation!
Never allow children or people
unfamiliar with these instructions
to use the machine.
Local regulations may restrict the
age of the operator. When not in
use store the machine
out of reach of children.
The extension lead must have
a cross section in accordance
with the operating instructions
and be protected against
splashed water. The connection
must not be in water.
Always wear gardening gloves
when handling or working near
the sharp blades.

ELECTRICAL SAFETY

Always check that
corresponds to the
voltage on the
Warning! Switch off, remove
plug from mains before adjusting,
cleaning or if cable is cut,
damaged or entangled.
The blades continue to rotate
for a few seconds after the
machine is switched off.
Caution – do not touch the
rotating blade.
Your machine is double insulated
for safety and requires no earth
connection. The operating
voltage is 230 V AC, 50 Hz (for
non-EU countries 220 V, 240 V
as applicable). Only use
approved extension cables.
Contact your ELEM GARDEN
TECHNIC Service Centre for
details : sav@eco-repa.com
Extension cords/leads should
only be used if they comply with
H05VV-F, H05RN-F types or IEC
type design (60227 IEC 53,
60245 IEC 57).
the power
supply
rating plate.
36