Using The Recycling Mode; Electrical Connections; Utilisation En Version Evacuation Using The Evacuation Mode; Using The Evacuation Mode - Brandt AD1036X Guide D'utilisation

Keep this user guide with your appliance. If the appliance is ever sold or transferred to another person,
ensure that the new owner receives the user guide. Please become familiar with these recommendations
before installing and using your oven. They were written for your safety and the safety of others
0
Identification
0.1
Installation
- The appliance must be unplugged during installa-
tion or when any repairs or maintenance work is
being performed.
- Ensure that the network voltage corresponds to the
voltage noted on the identification plate located
inside the hood.
- If the electrical installation at your residence
requires any changes in order to hook up your
Appliance, call upon a professional electrician.
- If the hood is being used in evacuation mode, do not
connect the appliance to a combustion gas exhaust
duct (boiler, chimney, etc.) or to a CMV (controlled
mechanical ventilation) system.
- Under no circumstances should the exhaust duct
empty into the attic.
- Install the hood at a safe distance of at least 70 cm
from an electric, gas or combined cooking hob.
1.1

ELECTRICAL CONNECTIONS

During installation and maintenance operations,
the appliance must be unplugged from the elec-
trical grid; fuses must be cut off or removed.
The electrical connections are made before the
appliance is installed in its housing.
Ensure that:
- the electrical installation has sufficient voltage,
- the electrical wires are in good condition,
- the diameter of the wires complies with the
installation requirements.
1.2
UTILISATION EN VERSION EVACUATION

USING THE EVACUATION MODE

If you possess an outlet to the exterior (fig. 1)
Your hood can be connected to this outlet using
a flue (minimum diameter Ø mm that is enam-
elled, in aluminium, flexible or made of inflamma-
ble material). If your flue is less than 125 mm in
diameter, you must use the recycling mode.
1.3

USING THE RECYCLING MODE

If you do not possess an outlet to the
exterior (fig. 2)
All of our appliances can be used in recy-
cling mode.
In this case, you should add an active car-
bon filter which will keep in odours.
(See Chapter 3: Changing the carbon fil-
ter.)
Warning
This appliance is delivered with a H 05 VVF
power cord that has three-0.75 mm
tors (neutral, phase and ground). It must be
connected to the main power supply (which
should be a 220-240 V single phase current)
via a CEI 60083 standardised socket that
should remain accessible after installation, in
keeping with installation guidelines.
We cannot be held responsible for any acci-
dent resulting from an inexistent, defective or
incorrect ground lead. The fuse for your
installation must be 10 or 16A. If the power
cable is damaged, call the after-sales service
department in order to avoid danger.
If the electrical installation at your residence
requires any changes in order to hook up your
appliance, call upon
electrician.
If the hood displays any malfunctions,
unplug the appliance or remove the fuse cor-
responding to the electrical socket where
your appliance is plugged in.
The hood must be installed in compliance with
all applicable regulations concerning the venti-
lation of premises. In France these regulations
are described in DTU 61.1 from the CSTB. In
particular, the evacuated air should never be
conveyed to a duct used to evacuate smoke
from appliances that use gas or other com-
bustible fuels. Unused ducts may only be used
after approval from a competent specialist.
Accessible parts may become hot when used
with cooking appliances.
EN
conduc-
2
a professional
19