GE Profile 22 Manuel D'utilisation page 10

Masquer les pouces Voir aussi pour Profile 22:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

About the shelves and bins.
Not all features are on all models.
Snugger
Refrigerator bin
Freezer tilt-out bin
Press tab and pull shelf forward
to remove
10
Refrigerator Door Bins and Freezer Door Tilt-Out Bins
Bins
The larger refrigerator door bins and freezer
tilt-out door bins are adjustable.
To remove: Lift the front of the bin straight up,
then lift up and out.
To replace or relocate: Engage the back side
of the bin in the molded supports on the door.
Then push down on the front of the bin. Bin will
lock in place.
The snugger helps prevent tipping, spilling or
sliding of small items stored on the door shelf.
Place a finger on either side of the snugger
near the rear and move it back and forth
to fit your needs.
Slide-Out Spillproof Shelf
The slide-out spillproof shelf allows you to
reach items stored behind others. The special
edges are designed to help prevent spills from
dripping to lower shelves.
To remove:
Slide the shelf out until it reaches the stop,
then press down on the tab and slide the shelf
straight out.
QuickSpace
Shelf
This shelf splits in half and slides under itself for
storage of tall items on the shelf below.
This shelf can be removed and replaced or
relocated just like Slide-Out Spillproof Shelves.
Top Freezer Bins
Do not block
Top freezer bin
Do not block
Top freezer bin (on some models)
To replace or relocate:
Line the shelf up with the supports and slide
it into place. The shelf can be repositioned
when the door is at 90° or more. To reposition
the shelf, slide the shelf past the stops and
angle downward. Slide shelf down to the
desired position, line up with the supports and
slide into place.
Make sure you push the shelves all the way
back in before you close the door.
On some models, this shelf cannot be used in
the lowest position.
NOTE:
Be careful when
placing items in
the top bin. Make
sure that items
do not block or
fall into the ice
chute.
NOTE:
Part must be in
place as shown
for proper ice
dispensing. Food
cannot be stored
in this location.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Profile 23Profile 25Profile 26Profile 27Profile 29

Table des Matières