Displaying Temperatures; Freezing The Readings; Viewing The Max, Min, And Avg Readings; Replacing The Batteries - SKF TKDT 10 Mode D'emploi

ООО "Индастриал Партнер"
Авторизованный дистрибьютор SKF

8. Displaying Temperatures

1. Press
C F
•
2. Hold or attach the thermocouple(s) to the measurement location.
The temperature reading appears in the primary display.
3. Press
T
1
T
-
1
T1-T2 readings in the primary or secondary display.
Note:
The display shows "- - - -" when a thermocouple is not connected.
The display shows OL (Off Limit) when the temperature being measured
is outside the thermocouple's measurement range.

9. Freezing the readings

1. Press
HOLD
The display shows HOLD.
2. Press
T
1
T
-
1
in the primary or secondary display.
3. Press
HOLD

10. Viewing the MAX, MIN, and AVG Readings

1. Press
MAX
MIN
the average (AVG) readings. The elapsed time since entering
MAX, MIN mode, or the time at which the minimum or maximum
occurred appears on the display.
2. Press
MAX
MIN

11. Replacing the Batteries

1. Turn off the thermometer.
2. Remove the screw and open the battery door.
3. Insert 3 ™ new LR03 batteries.
4. Close the battery door and tighten the screw.
SKF TKDT 10
www.skf.indpart.ru
to select the correct temperature scale.
K
•
to toggle between showing the T1, T2 and
T
2
T
2
to freeze the readings on the display .
to toggle showing the T1, T2 or T1-T2 readings
T
2
T
2
again to turn off the HOLD function.
to step through the maximum (MAX), minimum (MIN), or
button for 3 seconds to exit MAX, MIN and AVG mode.
Техническая поддержка:
mail@indpart.ru, 8(495)223-07-69
mail@indpart.ru
8(495)223-07-69
9