Table des Matières
Publicité
6
4 mm
1.
2.
5 mm
4 mm
English
Installation
Close the stops using a 4 mm
Allen wrench.
Cut the plaster shield so that it extends ¹⁄₁₆" - ⅛"
from the finished wall surface.
Seal the wall around the
plaster shield with waterproof
sealant (1).
Failure to seal the wall
can lead to possible water
damage.
Remove the flush insert screw, flush insert, and
seals (2).
Insert the function block.
Install and tighten the function block screws using
a 4 mm Allen wrench.
Publicité
Table des Matières
