Replacing The Lamp; Installation - Electrolux SB339NCN Notice D'utilisation

58 www.electrolux.com
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.

7. INSTALLATION

WARNING!
Refer to Safety chapters.
7.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
7.2 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
7.3 Installation and replacing of
the CLEANAIR CONTROL filter
On delivery the carbon filter is in a plastic
bag to preserve performance. The filter
should be placed in the drawer before
the appliance is turned on.
1. Open the drawer.
2. Take the filter out of the plastic bag.
3. Insert the filter in the drawer.
4. Close the drawer.
To get the best performance the carbon
air filter should be changed once every
year.
New active air filters can be purchased
from your local dealer.
The air filter is a consumable
accessory and as such is not
covered by the guarantee.
7.4 Installation of the appliance
and door reversal
Please refer to separate
instructions on installation
(ventilation requirements,
levelling) and door reversal.