Trebs Comfortcook Mode D'emploi page 42

Show code
Fault
G. Common malfunctions and Ways of solving problems
If the following symptom happens in the course of using, it is not completely the problem
of our products. Please have a double check before sending it for maintenance.
Symptom
The indicator is not
on
Can't close the lid
Can't open the lid
Leakage of the lid
Leakage of float
valve
The float valve can't
go up
Can't make the food
ripe or it takes a long
time
Can't keep warm
automatically
Feel like electric
shock when
touching the cover
If the problems still exist after the above-checking, please contact right away with us.
Thank you for your support.
E1 E2
sensor cut sensor
circuit circuit
Reason
Haven't switched on the power.
The gallbladder isn't placed well.
The push bar is locked by the
float value.
The float value is not down
after exhausting the air.
Didn't close the lid well
Didn't put the seal ring in it
There is food particles in the gallbladder
There is breakage on the gallbladder
There is food residue in the
small ring of the float valve
There is breaking on the small ring of the
float valve
The exhaust valve isn't moved to the sealed
position.
There is not enough food and water
There is breakage on the small ring of the
float valve
The cooking time is too short
There's food residue between the
inner pan and heating plate
The heating plate and inner pan distort
The heating plate doesn't work well
The parts for keeping warm is broken
Leakage of electricity
E3
short over
temperature
Methods
*Please check if there is power or not
*Please check if the switch is on or not
Place the gallbladder well
Move the push bar with hand
Use chopsticks to press the float value
slightly
Please close the lid well
Please put well the seal ring
Please clean the seal ring
Please change a new one
Clean small ring of the float valve
Please change a new one
Place it correctly
Put enough food and water
Contact with us for assistance
Proportionally prolong the cooking time
Check abd remove the residue
Contact with us for assistance
Contact with us for assistance
Contact with us for assistance
Contact with us for assistance
E4
Signal switch
failure