FUXTEC FX-KM196 Mode D'emploi page 33

Original-Bedienungsanleitung Benzin-Kehrmaschine FX-KM196_de_en_fr_ita_rev07
Fuel
Use lowest available octane unleaded fuel. When filling, place the machine
in a horizontal position. Always replace old fuel. Always stop the engine
when fueling. Never fill up with fuel on a hot engine. Never use gasoline
mixed with oil.
Operation - Start and Stop
Cold Engine
Activate the engine choke. Set the throttle control on full speed. (Figure 8)
First pull the starting rope a couple of times, shortly, until it feels tight. Pull
the starting rope slowly to the point where it feels tight, place your left hand
on the engine in order to hold back, and pull the starting rope hard once.
When the engine runs, deactivate the choke.
NOTICE: NEVER LET THE STARTING ROPE WIND AGAIN BY ITSELF.
Follow it all the way back with your hand. If the engine does not run in spite
of several attempts, this may be caused by the fact that there is too much
fuel in the cylinder/carburettor, and that the spark plug has become moist.
Remove the plug and wipe it off.
Stop the Engine:
Set the throttle control in position "Stop". Set the throttle lever to idle and
let the engine run for 12-20 seconds before the lever is moved to stop.
Never leave the sweeper without stopping the engine.
NOTICE: Do not turn off the engine by switching on the choke, as this may
result in damage to the engine.
Figure 8
33