Loewe 200 Mode D'emploi page 12

Connection
Cabling of Loewe TV set (chassis SL2xx) – Subwoofer 200 – speaker
➠ The TV set must be equipped with a Digital Audiolink.
You can either connect the subwoofer via a network cable (Cat. 5e or higher) and
the Converter Digital Audiolink / Audiolink (included with the Loewe Subwoofer
200, order no. 50212T/U/W30) or you can connect it wirelessly to a compatible au-
dio source via the Module Wireless AudioLink which can be optionally retrofitted.
If you wish to connect the subwoofer using the network cable, connect the Con-
verter Digital Audiolink / Audiolink to the 25-pin Audiolink socket
subwoofer. Use the network cable to connect the Digital Audiolink of the TV set
to the socket of the Converter Digital Audiolink / Audiolink.
- 12
of the
2
Converter Digital Audiolink / Audiolink
Front Front
left right
Connect the speaker cable to the speaker according to the corresponding installa-
tion instructions. One of the two wires is usually marked black. Connect this black
marked cable respectively with the black screw terminal Speaker Out
Subwoofer 200 (connection diagram see figure right) and the black terminal on
the speaker. For this, turn the screw lock of the relevant terminal on the subwoofer
anticlockwise about 5 turns. Guide the wire end into the screw terminal from below
and close the screw terminal by turning it clockwise. Connect the unmarked wires
to the red terminals.
Use the mains cable supplied to connect the 220-240 V socket
to a 220-240V 50/60 Hz socket.
to the
3
of the subwoofer
4
Loewe Subwoofer 200
Mains cable
Network cable
Loewe TV set (SL2xx)