Loewe 200 Mode D'emploi page 13

Connection
Cabling of Loewe TV set (chassis L27xx/SL1xx) – Subwoofer 200 – speaker
➠ The TV set must be equipped with an integrated digital multi-channel audio
decoder. If this has not been done at the factory, please consult your dealer
and ask them for the suitable Loewe upgrade kit.
You can connect the subwoofer either via an Audiolink cable or via the optional
upgrade Module Wirless AudioLink wirelessly with a compatible audio source
(e.g. Loewe MediaVision 3D). If you connect the subwoofer via the Audiolink cable,
install it with the 26-pole connector at the Loewe TV set and at the subwoofer
(socket Audiolink ).
2
Front Front
left right
Loewe TV set (L27xx - SL1xx)
Connect the speaker cable to the speaker according to the corresponding installa-
tion instructions. One of the two wires is usually marked black. Connect this black
marked cable respectively with the black screw terminal Speaker Out
Subwoofer 200 (connection diagram see figure right) and the black terminal on
the speaker. For this, turn the screw lock of the relevant terminal on the subwoofer
anticlockwise about 5 turns. Guide the wire end into the screw terminal from below
and close the screw terminal by turning it clockwise. Connect the unmarked wires
to the red terminals.
Use the mains cable supplied to connect the 220-240 V socket
to a 220-240V 50/60 Hz socket.
to the
3
of the subwoofer
4
Loewe Subwoofer 200
Mains cable
Audiolink cable
13 -