Operating Determinations - EuroLite 50530550 Mode D'emploi

The LED RGB Ribbon with Controller falls under protection-class III. The device always has to be operated
with an appropriate transformer. Always plug in the power unit last.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting effect for creating decorative effects.
The LED RGB Ribbon Controller is only allowed to be operated with an alternating voltage of 230 V, 50 Hz
and was designed for indoor use only. This product must only be operated with the appropriate power unit.
The power unit falls under protection-class 2.
The LED RGB Ribbon is allowed to be operated with a direct current of 24 V and was designed for indoor
use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc., as well as for
home use.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
The device must never be installed over areas, where persons may be seated or walk by.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
- - -m
The symbol
between light-output and the illuminated surface must be more than 0.1 meters.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
HEALTH HAZARD!
determines the minimum distance from lighted objects. The minimum distance
9/22 00018991.DOC, Version 1.2