Hydraulic Connection - Hayward element HPE0811D Guide De L'utilisateur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The installation must be carried out by a qualified installer.

Choose an area where the air outlet and sound level will not bother the swimmers.

Choose a place that allows for the clearance required (50cm minimum around the heat pump).

For improved sound insulation, you are advised to install the Element Pump on silent blocks (not supplied)

The floor structure supporting the cabinet should be strong, flat and prepped to drain the condensate water.

for efficiency purposes, void having too great a length of piping between the heat pump and the pool pump room/ housing.

Once all connections have been completed, check for leaks and finally wrap valves and pipes with anti-condensation insulation.

IMPORTANT: Before performing any work on the ELEMENT heat pump, ensure that the the main power switch is turned OFF.

Identify the stickers :

Entrée d'eau = Inlet water

Sortie d'eau = Outlet water

The connection is to be made using a "BY PASS" system» on the filtration circuit, situated between the filter and the water treatment device.

TESTING PRESSURE: 3 bar

SERVICING PRESSURE: 1 bar

Necessary supplies :

3 manually operated by pass (ball) valves

Degreasant

Solvent cement

Connections

Hot water circuit

Cold water circuit

Floor structure should be adequately strong

and fit to drain the condensate water