Guardian G2-100KHX1 Mode D'emploi Et Garantie page 4

Attach the Aluminum Extension Legs to the Aluminum Main Frame:
1. Depress the pushbuttons on the main frame and place the aluminum extension legs into the main frame tube until secured at
the desired height. Repeat with the three remaining legs. Ensure all four extension legs are installed at the same height and the
push-buttons are fully protruded before using.
Note: Improperly inserting the legs of the backrest may cause damage to the product. When the legs have been installed to the seat
bench, the legs of the backrest will hangover the side of the table and are pointing towards the floor.
Installing and Assembling the Back Rest: (Only pertains to G2-100KHX1)
1. Hold one tube of the aluminum backrest frame so that the pushbuttons are facing upwards; slide the tube into the cross brace so that
the brass pushbuttons protrude upward from the bracket's hole and lock into place. The aluminum backrest frame has two adjustable
settings. Repeat with the second tube of the aluminum back rest frame. Turn the bench right side up.
2. Place the bench right side up to assemble the backrest to the aluminum backrest frame.
3. Grab the backrest by the handle and position it into place fitting the pre-formed indentations located on the backside of the backrest
so that the screw holes line up to the predrilled holes of the aluminum backrest frame. Attach and secure the hand screw. Once all
four screws are in place, tighten for safety.
Assembling the Arm Rests:
1. Insert each padded arm rest on either side of the seat bench. Ensuring the curved bar extends outward from the seat bench.
The pushbuttons should lock securely into place.
Adjusting the Bench to the Proper Height:
1. While standing in front of the assembled bench, as if preparing to sit, the back of the users knees should touch the front side of the
seat bench. This should allow the users feet to be firmly on the floor while properly seated. Adjust the leg extensions as needed.
2. Ensure all four rubber tips rest evenly on the floor.
Cleaning
The bath bench can be easily cleaned with regular household cleaning products. Use a non-abrasive cleaner with warm water.
DO NOT use abrasive powders or scouring pads.
Maintenance
• Periodically inspect the bath bench for damage or loose components.
• Ensure all pushbuttons are protruded from the extension legs.
• Check the rubber feet on the leg extensions for rips or wear. If any of these conditions exist, or if they are missing, replace
them immediately.
4
G2-100KHX1 G2-200KHX1 (PIC-00303)
Rev: 09/08/2020