Table des Matières
Publicité
8. Avoid places subject to shock or vibration.
A device such as a contact breaker may be a vibration source. Set the Power Supply as far as
possible from possible sources of shock or vibration.
9. If the Power Supply is used in an area with excessive electronic noise, be sure to separate the
Power Supply as far as possible from the noise sources.
10. Don't use the product in the environment with strong electromagnetic field, corrosive gas and conductive
substance.
Precautions in Using the product:
When the product is used under the circumstance or environment below, ensure adherence to limitations of
the ratings and functions.
Also take countermeasures for safety precautions such as fail-safe installations.
1. Under the circumstances or environment which are not described in the instruction manual.
2. For nuclear power control, railway, aircraft, vehicle, incinerator, medical equipment, entertainment
equipment, safety device etc...
3. For applications where death or serious property damage is possible and extensive safety precautions are required.
4. Terminal block covers are necessary to be used when connecting the input and output wire.
5. Don't recommend using input power source with large inductance, which may cause power supply operate
unstably.
6. DLP180/E and DLP240/E are capable of providing hazardous energy output (240VA), the end equipment
manufacturer must provide protection to service personal against inadvertent contact with output terminals.
These terminals must not be user accessible.
Note: CE MARKING
CE Marking, when applied to a product covered by this handbook indicates compliance with the low
voltage directive (2006/95/EC)in that it is complies with EN60950-1.
1. Terminal Explanation
1-1.1 DLP75/E
+V
V.ADJ
H
DC ON
ALM
BAR CODE
L
-V
IND.CONT.EQ.
45JB
N
DLP/E Series
INSTRUCTION MANUAL
1-1.2 DLP75/C2E
+V
-V
DC ON
ALM
BAR CODE
IND.CONT.EQ.
L
N
TDK-Lambda
45JB
Publicité
Table des Matières
