Spektrum AR10000 Guide De L'utilisateur page 9

To Test
Confirm the failsafe setting is correct by turning off the transmitter. The throttle should go to
the preset low throttle position.
CAUTION: Make sure the aircraft is restrained on the ground. If failsafe is not set,
your aircraft might advance to mid or full throttle.
Hold Last Command
If you lose connection, all channels except for throttle channel hold last given command and
the aircraft continues on its path. So, if you were turning when connection was lost, your
aircraft would continue turning.
How to Program
1. Leave the bind plug in the bind port through the entire binding process.
2. Remove bind plug only after receiver connects to transmitter
To Test
Confirm the failsafe settings are correct by turning off the transmitter. All channels except for
the throttle should hold the last command.
CAUTION: Make sure the aircraft is restrained on the ground. If failsafe is not set,
your aircraft might advance to mid or full throttle.
Preset Failsafe
If the signal is lost, all channels are driven to their failsafe position set during binding.
Preset Failsafe is ideal for sailplanes, as spoliers can be deployed during loss of signal,
preventing a flyaway.
How To Program
1. Insert the bind plug and power on the receiver.
2. When the receiver LEDs blink indicating bind mode, remove bind plug before
binding the transmitter to the receiver.
3. LED lights will continue to blink.
4. Move transmitter's control sticks and switches to the desired Preset Failsafe positions
then turn it on in bind mode.
5. The system should connect in less than 15 seconds.
NOTICE: Failsafe features vary according to receiver, so if using a receiver other
than the AR10000, consult your receiver's instructions for the failsafes that apply.
Before flight, ALWAYS confirm your binding is good and failsafe is set. To do this, make
sure the system is connected, turn your transmitter off. Confirm that low-throttle is active.
CAUTION: Make sure the aircraft is restrained on the ground. If failsafe is not set,
your aircraft might advance to mid or full throttle.
Range Testing
Before each flying session and especially with a new model, perform a range check. All
Spektrum aircraft transmitters incorporate a range testing system which, when activated,
reduces the output power, allowing a range check.
1. With the model restrained on the ground, stand 30 paces (approx. 90 feet/28 meters)
away from the model.
30 paces (90 feet/28 meters)
EN