Status Leds - Balluff BNI PNT-508-055-P067 Notice De Montage

BNI PNT-508-055-P067 / BNI PNT-538-055-P067
Network interface
Design and function
FE connection
PROFINET Port 1
Power supply input
Port 0
Port 2
Port 4
Port 6
The Profinet IO-Link master is a decentralized and
configurable gateway that processes and evaluates the
input and output signals of standard sensors and actuators
as well as process data from connected IO-Link devices.
The data is transmitted via an existing fieldbus interface to
a higher-level controller set up by the user for further
processing.
A web server is available on the IO-Link master for
configuration and diagnostics.
Display elements
Port/Pin LEDs
– LED 00 – Port-pin 4
– LED 01 – Port-pin 2
Port/Pin LEDs Standard-Port
Display Meaning
Off State of input or output pin is 0
Yellow State of input or output pin is 1
Both LEDs Short circuit of sensor supply between
flashing red pin 1 and pin 3
Red Short circuit at output on pin 2/4 against
pin 3
Red No high signal at diagnostic input
Red 24 V input signal on configured output
(actuator warning)
www.balluff.com
Mounting hole
PROFINET Port 2
Power supply
output
Port 1
Port 3
Port 5
Port 7
Mounting hole
Display elements
Port/Pin-LEDs IO-Link-Port
Display Meaning
Green IO-Link connection active
Flashing No IO-Link connection or incorrect
green IO-Link device
Green, fast IO-Link: Preoperate during data storage
flashing
Red, fast Validation failed / incorrect configuration
flashing of the IO-Link data length
Red, fast Data storage failed / incorrect device for
flashing data storage
Red IO-Link: Short circuit of pin 4 against
pin 3
Status-LEDs
LED Display Meaning
US Green Input voltage OK
Red flashing Input voltage low (< 18 V)
UA Green Output voltage OK
Red flashing Output voltage low (< 18 V)
Red No output voltage present
(< 11 V)
SF Off No error
Red Watchdog timeout; channel,
general or extended diagnostics
present; system error
Red flashing Service DCP signal started via
bus
BF Off No error
Red Low speed of physical link; or no
physical link
Red flashing No data exchange or no
configuration
MS Green No error
Blue flashing Ping command
Blue Limit exceeded by internal
counter (e.g. operating hours)
Yellow Sensor supply below 18 V
flashing
Actuator supply below 18 V
No sensor supply 0 V
No actuator supply 0 V
Temperature too low
Temperature too high
Overvoltage
Red Internal failure
100 Off Transmission rate: 10 Mbit/s
Yellow Transmission rate: 100 Mbit/s
XF1/2 Green Data transfer
flashing
english 2