Westfalia 304 054 300 107 Instructions De Montage page 16

Installing the electrical kit
1. Disconnect the negative battery terminal.
2. If necessary, remove the following coverings and panels:
•
In the luggage trunk
Covering of luggage trunk bottom
-
Right-hand and left-hand side covering of the luggage trunk
-
•
From the rear end plate
Remove the covering for the cable leadthrough on the lower surface on the right-hand
-
and left-hand side.
•
On the left-hand side of the vehicle
Access strips
-
3. The Y-connector for connecting the right tail light is connected to the cable harness with a
white 4/2-pin plug. Unplug the 4/2-pin plug to mount the cable harness.
4. Lay the socket end and the cable end with the 4/2-pin plug as follows:
Starting in the luggage trunk through the cable leadthrough (Fig. 1/5) under the left tail
-
light opening to the outside
From there to the cross-bar of the towing device
-
Then to the socket holder plate (Fig. 1/7)
-
5. Insert the rubber grommet into the cable leadthrough (Fig. 1/5).
6. Lay the cable end with the 4/2-pin plug further along the cross- bar through the cable
leadthrough (Fig. 1/8) under the right tail light opening into the luggage trunk.
7. Insert the rubber grommet into the cable leadthrough (Fig. 1/8).
8. Secure the cable harness on the cross-bar using cable ties.
Socket installation
9. Fit the socket gasket to the cable harness (Fig. 1/7).
10. Connect the cable harness to the socket housing in accordance with the socket pin
assignment plan (Fig. 1/7) and push the rubber grommet towards the socket.
11. Screw the socket onto the holding plate (Fig. 1/7) using the supplied screws and nuts.
16
Installation Instructions: Electrical System for Towing Hitch
304 054 391 102 - 001 - 04/08 Citroen Berlingo