Operation With Iphone; Pairing Charger With Iphone - HITEC X4 Advanced Mode D'emploi

7. Display Information
When the program for a slot is completed, „DONE" will
displayed. With the exception of DISCHARGE mode, top off
charge and trickle charge (continuous) will be applied. For
CHARGE mode, the total charged capacity will be displayed.
For REFRESH & ANALYSE, BREAK-IN, DISCHARGE mode, the
total discharge capacity will be displayed.

8. Operation with iPhone

8.1. Pairing Charger with iPhone

Pairing occurs when two Bluetooth devices communicate
with each other and establish a connection. A record of
information about this connection is then stored in the
memory of each device.
To begin pairing with your iPhone, iPod or iPad:
1. Connect the power adapter DC connector to the charger
and then plug the power adapter into outlet (100-240 V AC,
50/60 Hz).
2. Insert AA or AAA battery. When a new battery is inserted
and detected, the battery sign and "CHARGE" in correspond
slot will blinking. Please wait fi ve seconds, the charger
will proceed to the default mode which is charging.
3. Push and hold "ENTER" button for fi ve seconds, the
bluetooth LED indicator on the charger is blinking in blue
to show the charger is discoverable.
4. Select the Bluetooth menu from your iPhone or iPad and
ensure the Bluetooth is turned on.
Useful Notes And Tips
· The charger can hold up eight paired devices. When the memory is full and additional device cannot be
paired. If you want to pair new devices, you need clearing all the memory.
· Clearing memory: To clear the charger memory of all devices, Press and hold "UP" and "DOWN" button
simultaneous for fi ve seconds. The charger clears all devices from its memory.
20
Once you pair a device with the HiTEC X4 Advance charger,
you should not have to pair it again. The HiTEC X4 Advance
charger can pair with up to eight devices. However, it can
only connect to, and control the HiTEC X4 Advance charger
from one device at a time.
5. Find the HiTEC X4 Advance charger which will be
identifi ed as "HITEC + 4 digits serial number". For
example, HITEC1234 and select it. Confi rm that you
want to connect the HiTEC X4 Advance charger with
your iPhone or iPad by selecting it.
6. A confi rmation "Connected" appears on your phone
after you have selected the HiTEC X4 Advance charger. It
takes few seconds to fi nalize the pairing process, please
wait for while.
7. The Bluetooth indicator, located on the right side of
charger remains steadily on.
8. Your HiTEC X4 Advance charger is now connected with
your iPhone or iPod.