Using The Tv; Watching Tv; Changing Channels; Switching Modes - Insignia NS-F20TR Guide De L'utilisateur

Using the TV

Note
Unless noted, all buttons in the following
instructions are remote control buttons.

Watching TV

Note
The first time you connect your TV combo to an
antenna or cable TV, it automatically scans for
and memorizes available channels.
To watch TV:
1 Connect your antenna, cable TV, or satellite
receiver.
2 Plug your TV combo power plug into a power
outlet.
3 Press the POWER button to turn on your
TV combo.
4 Press the CH or CH
number buttons to select a channel.
Note
If you are using a cable converter box or satellite
receiver, set your TV combo to channel 3, 4, or
AUX, then use your cable converter box or
satellite receiver to change channels.
5 Press the VOL. or VOL.
the volume. Press the MUTE button to mute
or un-mute the sound.

Changing channels

To select a memorized channel:
• Press the CH or CH
Or
• Press the appropriate number buttons. If you
are selecting a channel number larger than
100, press the +10/+100 button, then press
the number buttons for the two lower digits of
the channel button. For example, if you want
to select channel 120, press the +10/+100
button, press 2, then press 0.
Major and minor channels in digital TV (DTV)
A digital TV (DTV) channel has a main (major)
channel and may have one or more
sub-channels (minor channels).
When you use the CH
select a channel, the major channel is tuned first
followed by the minor channels.
To select a minor channel with the number
buttons:
• Press the number buttons for the major
channel, then press the number buttons
for the minor channel. For example, if the
major channel is 12 and the minor
channel is 3, press 1, then 2, then 0, then
3. (You must press the 0 if you are
selecting a single-digit minor channel
number.
10
Insignia NS-F20TR 20" Flat Tube TV/DVD/VCR Combo

Switching modes

button or use the
button to adjust

Adjusting picture settings

button.
or CH buttons to
www.insignia-products.com
To search for a minor channel for the major
channel your are currently watching:
• Press the +10/+100 button.
If the major channel has a one-digit channel
number, press the number button for the
major channel, press the ENTER button,
then press the number button for the minor
channel.
If the major channel has a two-digit channel
number, press the number buttons for the
major channel, then press the number button
for the minor channel. If you press the
ENTER button after you enter the two-digit
major channel number, your TV combo tunes
to the smallest minor channel number.
To switch modes:
• Press the INPUT button one or more times to
select the TV/VCR or DVD mode. The
corresponding indicator light turns on the
front of your TV combo. For the location of
the indicator lights, see "Front control panel"
on page 5.
Note
TV/VCR mode includes analog TV, DTV, or AUX
mode. To use the VCR, select the TV/VCR mode.
Note
Your TV combo saves this setting even if you turn
off your TV combo or disconnect the power.
To adjust picture settings:
1 Press the PICTURE button.
2 Within five seconds, press the PICTURE
button to select the setting you want to
adjust. You can select:
• BRIGHT–Increases or decreases the
brightness.
• CONTRAST–Increases or decreases the
contrast.
• COLOR–Sharpens or softens the color.
• TINT–Adjusts the tint from purple to
green.
• SHARPNESS–Increases or decreases
the sharpness.
3 Press the or button to adjust the setting.