Restore Factory Settings - HomeMatic HM-LC-Sw1-Pl-DN-R5 Mode D'emploi

Corridor
Cellar
7

Restore factory settings

The factory settings of the switch actuator with power metering can be
restored manually. If you do this, you will lose all your settings.
Before restoring the factory settings, please delete the device
from the user interface WebUI first.
To do this, proceed as follows:
• Press and hold down the channel button (A) for at least four
seconds until the device LED (B) will slowly start flashing orange.
• Release the button again.
Audio signal
Measured
Kitchen
value
< 100 W
Restore factory settings
35