Teaching-In To A Homematic Central Control Unit - HomeMatic HM-LC-Sw1-Pl-DN-R5 Mode D'emploi

If teaching-in was successful, the device LED (B) of the switch actuator
will flash green for one second. If teaching-in failed, the device LED will
light up green for two seconds. In this case, please try again.
After successfully teaching-in the device you can switch on and off
connected loads e.g. with the HomeMatic Remote Control
If no teach-in operations are carried out, teach-in mode is
exited automatically after 20 seconds. If other devices are also
in teach-in mode, they will be taught-in.
5.2.2

Teaching-in to a HomeMatic Central Control Unit

Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in Central Control Unit programs
by using the HomeMatic software "WebUI". Therefore, your switch ac-
tuator has to be taught-in to the HomeMatic Central Control Unit first.
New devices are taught-in to the Central Control Unit via the Home-
Matic „WebUI".
Start-up
31