Bosch GBH Professional 36 V-LI Notice Originale page 12

12 | English
Inserting SDS-plus Drilling Tools (see figure G)
The SDS-plus drill chuck allows for simple and
convenient changing of drilling tools without the
use of additional tools.
GBH 36 VF-LI: Insert the SDS-plus quick change
chuck 2.
Clean and lightly grease the shank end of the
tool.
Insert the tool in a twisting manner into the tool
holder until it latches itself.
Check the latching by pulling the tool.
As a requirement of the system, the SDS-plus
drilling tool can move freely. This causes a cer-
tain radial run-out at no-load, which has no
effect on the accuracy of the drill hole, as the
drill bit centers itself upon drilling.
Removing SDS-plus Drilling Tools
(see figure H)
Push back the locking sleeve 5 and remove the
tool.
Inserting Drilling Tools without SDS-plus
(GBH 36 V-LI)
Note: Do not use tools without SDS-plus for
hammer drilling or chiseling! Tools without
SDS-plus and their drill chucks are damaged by
hammer drilling or chiseling.
Insert a key type drill chuck 20 (see "Changing
the Key Type Drill Chuck", page 11).
Open the key-type drill chuck 20 by turning until
the tool can be inserted. Insert the tool.
Insert the chuck key into the corresponding
holes of the key type drill chuck 20 and clamp
the tool uniformly.
Turn the mode selector switch 10 to the
"Drilling" position.
Removing Drilling Tools without SDS-plus
(GBH 36 V-LI)
Turn the sleeve of the key type drill chuck 20
with the drill chuck key in anticlockwise direc-
tion until the drilling tool can be removed.
1 619 929 779 | (22.8.07)
Inserting Drilling Tools without SDS-plus
(GBH 36 VF-LI) (see figure I)
Note: Do not use tools without SDS-plus for
hammer drilling or chiseling! Tools without
SDS-plus and their drill chucks are damaged by
hammer drilling or chiseling.
Insert the quick change keyless chuck 1.
Firmly hold the retaining ring 24 of the quick
change chuck. Open the tool holder by turning
the front sleeve 23 until the tool can be inserted.
Tightly hold the retaining ring 24 and firmly turn
the front sleeve 23 in the direction of the arrow
until a distinct latching noise can be heard.
Check the tight seating by pulling the tool.
Note: If the tool holder was opened to the stop,
then the latching noise possibly may be heard
while closing the tool holder and the tool holder
will not close.
In this case, turn the front sleeve 23 once in the
opposite direction of the arrow. Afterwards, the
tool holder can be closed (tightened) again.
Turn the mode selector switch 10 to the
"Drilling" position.
Removing Drilling Tools without SDS-plus
(GBH 36 VF-LI) (see figure J)
Firmly hold the retaining ring 24 of the quick
change chuck. Open the tool holder by turning
the front sleeve 23 in the direction of the arrow
until the tool can be removed.
Dust Extraction with the Dust
Extraction Attachment (Accessory)
Mounting the Dust Extraction Attachment
(see figure K)
For dust extraction, the dust extraction attach-
ment (accessory) is required. When drilling, the
dust extraction attachment retracts so that the
attachment head is always close to the surface
at the drill hole.
Press the button for depth stop adjustment 12
and remove the depth stop 17. Press button 12
again and insert the dust extraction attachment
into the auxiliary handle 18 from the front.
Bosch Power Tools