BORETTI B400 Mode D'emploi page 58

Important: prime the unit
To prime unit, run the steam cycle for 90 seconds by following the steps below:
1. Fill water reservoir between the "Min" and "Max" levels.
2. Fill the milk reservoir with water between the "Min" and "Max" levels.
3. Select one of the filters and place it on the porta-filter. Place the porta-filter in the unit
ensuring it is properly locked and place a cup under it. Also, make sure the tip of the
frothed milk dispensing tube is inside the cup.
4. Plug the appliance into the appropriate outlet.
5. Turn the power button on "I".
6. The three control panel lights will start blinking. Once these lights become solid, press
the cappuccino button twice.
7. Once this process is completed, the three control panels will turn on solid.
Now your unit has been primed and is ready to be used.
« USE
Filling the water reservoir
1. Fill the reservoir with water, you may either use a jar to fill it up or remove it from the unit
and then fill it up under the tap. If you have removed it from the unit to fill up with water,
please make sure to place it back tightly in its place. Fill the reservoir with the desired
amount of water ensuring it ranges within the"MIN" and "MAX" markings on the tank.
Never use warm or hot water to fill the water reservoir.
2. Close the water reservoir lid and place it back in the unit ensuring it fits tightly.
Filling the milk reservoir
If you plan to prepare cappuccino or latte, remove the milk reservoir from the unit and open
the lid then pour the quantity of cold milk you estimate you will need between the "Min"
and"Max" levels. When done, place the milk reservoir back in the unit ensuring it fits tightly.
Note: It is advised to use whole milk to get the best foam result.
Choose the filter
Select the filter to be used as follows:
1. FOR A SINGLE SHOT– use the filter for a single shot of espresso if using ground coffee.
2. FOR A DOUBLE SHOT OR TWO SINGLE SHOTS- use filter for a double shot.
58
1 2
B400-B401-B402