Before The First Use - BORETTI B400 Mode D'emploi

« PARTS
1. Water tank lid
2. Removable water tank
3. Espresso/custom button with indicator
4. Cappuccino/Froth button with
indicator
5. Latte/Clean button with indi-
cator
6. Indicator
7. Prota-filter
8. Cup height adjusting drawer
9. Drip tray
10. Power switch I/O
11. Frothed tube lever
12. Frothed milk dispensing tube
13. Milk reservoir lid
14. Suction tube
15. Removable/Clear milk reservoir
16. Porta-filter retention clip
17. Filter for single shot of espresso
18. Filter for double shot of espresso
19. Measuring scoop/tamper
« BEFORE THE FIRST USE
Cleaning and priming the unit prior to first use
Please refer to the "Parts" section to familiarize with the product and identify all parts.
1. Please make sure the unit is off "O" by pressing the power button located on the side of
the unit. Make sure it is unplugged from the electrical outlet.
2. Remove stickers and labels from the unit. Remove the orange silicon rubber ring from
the bottom of the water reservoir.
3. First remove and then wash the water reservoir, the milk reservoir, the porta-filter, the
three filters and measuring scoop in a mixture of mild detergent and water. Rinse each
thoroughly and place them back into the unit.
4. Refer to the instructions on "PLACING THE PORTA-FILTER" section before placing or
removing the porta-filter and filter from the unit.
NOTE: In order for your unit to work properly time after time, clean it after every use.
1
2
3
4
5
6
7
8
9
17
16
11
13
12
14
15
10
18
19
EN
57