Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 5 -
WARNING! To install non-Elkron ("OTHER") cameras, check that they can reply to a
HTTP request providing a snapshot in JPEG format with maximum resolution 1280x720.
Note: Use of "Static IP" is recommended.
For example, URMET "BOOST" cameras can be used (models: 1093/139M2 – 1093/141M2 –
1093/142M2 – 1093/176M2 – 1093/177M2 – 1093/178M2).
The following instructions are valid also for Elkron TC19 (80TC1U00133) and TC20 (80TC1V00133)
cameras.
Proceed as follows, if these cameras are used:
WARNING
!
version is lower, contact Customer Service (mail:
WARNING
!
firmware is lower, download the update from the Elkron website.
WARNING
!
Connect (V3.70 or higher). If the versions are not up-to-date, download the update from
the Elkron website.
Connect the LAN cable to the camera directly to the PC.
1.
Prepare and set up the following IP address and network parameters on the PC:
2.
IP:192.168.1.10 -- Subnet Mask: 255.255.255.0
Note: The default IP address of the camera is 192.168.1.168
Using Internet Explorer access the camera programming
3.
(192.168.1.168, user name: admin, password: admin)
Set IP address, Subnet Mask and Gateway (to select the default IP address, Subnet Mask
4.
and Gateway of the camera, connect to the router of your network and check the IP
address mode).
Select main stream resolution to 1280 x 720, save and quit.
5.
Connect the camera to your network.
6.
Reset the PC network parameters for operation on your network.
7.
Start Hi-Connect or IP-Connect.
8.
Configure the camera (see Step 4)
9.
Set the following programming parameters:
10.
IP address
User Name and Password
In "Full Image URL" enter the following string:
"/Snapshot/1/RemoteImageCapture?ImageFormat=2"
In "Image URL" enter the following string:
"/Snapshot/1/RemoteImageCapture?ImageFormat=2"
Save and transfer the programming to the Web Server.
OTHER
camera configuration
"
"
Check that the camera firmware is "1.1.9" or higher. If the camera firmware
Check that the Web Server firmware is "2.0" or higher. If the Web Server
Make sure you have the latest versions of IP-Connect (V1.10 or higher) or Hi-
stac@elkron.it
15/40
(non-Elkron cameras)
and ask for an update).
Publicité
Table des Matières
