Elkron IT500WEB Guide Rapide page 11

ENGLISH
1. To install the interface in MP500 control panels proceed in the following manner:

unclip the motherboard from its seat and tilt it;

position the interface at the bottom of the control panel in position A and secure it with the two
supplied screws;

to connect it, insert one flat cable connector in the interface and the other in the motherboard
connector (J11);

plug the LAN Ethernet cable in the RJ45 connector of the interface.
WARNING! The connection and disconnection of the optional parts and accessories must
always be carried out while the control panel is not electrically live (power line and battery
disconnected).
STEP 1 - Board installation
11/40
J11