Metrohm 822 Titration Mode D'emploi page 24

4.2 Signification des DELs
16
SER_OUT - bit 20:
SER_OUT - bit 21:
SER_OUT - bit 22:
SER_OUT - bit 23:
SER_OUT - bit 24:
Instructions pour appareil de dosage:
SER_IN - bit 0:
SER_IN - bit 1:
SER_IN - bit 2:
SER_IN - bit 3:
SER_IN - bit 4:
SER_IN - bit 5:
SER_IN - bit 6:
SER_IN - bit 7:
SER_IN - bit 8:
SER_IN - bit 9:
SER_IN - bit 10:
SER_IN - bit 11:
SER_IN - bit 12:
SER_IN - bit 13:
SER_IN - bit 14:
SER_IN - bit 15:
DOS_TYP2 Bit 2 definition of the chip
function
DOS_TYP3 Bit 3 definition of the chip
function
Bit 0 for stating the number of
P10000
pulses for the total volume
P20000 Bit 1 for stating the number of
pulses for the total volume
PWR Enables "Hot Plug & Play" of
the device and recognize
temporally unusual supply and
control data
UP Filling impulses for spindle
motor
DOWN Dosing impulses for spindle
motor
R_NRW Use data or set STROBE
impulse
Definition of the digital signals
MOT_INFO
SER_OUT bit 5 ... 10, 15 ... 17
MOT_INFO = L: Information about current
speed of the spindle motor
(MOT_D0...SN) and cock
position (ISTPOS0...2)
Information of the digital inputs
MOT_INFO = H:
IN0...2, NHWR, NPOR, OVERL,
EXP0...2
NRES Reset for dosimat controller
(L activ)
OUT0 Bit 0 digital output
OUT1 Bit 1 digital output
OUT2 Bit 2 digital output
POS0 Bit 0 for the default of the
desired cock position
POS1 Bit 1 for the default of the
desired cock position
POS2 Bit 2 for the default of the
desired cock position
Definition of the direction of
DIR
rotation of the cock motor
STOP_HM Signal to switch off the driver
stage of the cock motor
STOP_SM Signal to switch off the driver
stage of the spindle motor
P10000 Bit 0 for stating the number of
pulses for the total volume
Bit 1 for stating the number of
P20000
pulses for the total volume
822 Simulateur de courbes de titrage, Mode d'emploi