Télécharger Imprimer la page

Phonocar VM013 Notice De Montage Et D'emploi page 19

Publicité

RESISTIVE PROTOCOL
CONNESSIONI E SINCRONIZZAZIONE DELL' INTERFACCIA COMANDI AL VOLANTE
CONNECTING AND SYNCHRONIZING OF THE INTERFACE FOR STEERING-WHEEL CONTROLS
9
NERO / BLACK
ARANCIO-BIANCO / ORANGE-WHITE
MARRONE-BIANCO / BROWN-WHITE
IT - Il VM013 è dotato di Comandi al Volante Resistivi. In caso di incompatibilità, utilizzare le interfacce 04083-04085. Per i
collegamenti ai connettori originali dell'auto seguire gli schemi presenti sul manuale connessioni interfacce.
MEMORIZZAZONE DEI TASTI SUL VOLANTE Effettuare i collegamenti. Memorizzare le funzioni dei comandi al volante
seguendo il manuale delle interfacce.
MEMORIZZAZIONE PROFILO AUTORADIO A sincronizzazione avvenuta, il led lampeggerà con colore verde e
continuerà a lampeggiare fino a quando non si selezionerà il profilo autoradio Phonocar VM057 / VM034.
La selezione avverrà premendo 4 volte il tasto Volume+ ed il Led eseguirà 5 lampeggi verdi.
Premere SEEK per memorizzare.
PROGRAMMAZIONE AUTORADIO Vedi pag. 17
RESET INTERFACCIA Staccare il connettore dalla centralina e tenendo premuto il tasto PRG, reinserire il connettore. Il LED
della centralina inizierà a lampeggiare lentamente poi velocemente a questo punto togliere la pressione dal tasto PRG.
L'avvenuto RESET sarà confermato con un solo lampeggio di colore rosso del LED.
EN - The VM013 is fitted with Resistive Steering-wheel Commands. In case of incompatibility, use interfaces 04083 04085.
To connect to the Original car-connecters, stick to the schemes shown on the Interface Connections-Manual.
MEMORIZING THE STEERING-WHEEL KEYS Effect the connections. Memorize the steering-wheel functions as stated
on the Interface-Manual.
MEMORIZING THE CAR-RADIO PROFILE When synchronization has taken place, Led will flash Green. It will continue
flashing until you select the radio-profile Phonocar VM057 / VM034.
Selection takes place by pressing 4times the key Volume+. Led will flash 5times Green. Press SEEK to memorize.
PROGRAMMING THE CAR-RADIO page 17
RESET INTERFACE Separate the connector from the central-unit. Keep PRG-key pressed and re-introduce the connector.
LED of central-unit will start flashing slowly and then rapidly. At this point, lift finger from the PRG-key. RESET has
successfully been carried out when LED flashes only one time Red.
IT - Le istruzioni delle interfacce sono presenti anche sul nostro sito WWW.PHONOCAR.IT area manuali.
EN - The Instructions-Manuals of our Interfaces are also available on our web-site WWW.PHONOCAR.IT Download-Manuals-Area.
GND
KEY 1
KEY 2
19
VERDE / GREEN
ROSA / PINK
GRIGIO / GREY
IT/EN

Publicité

loading