Télécharger Imprimer la page

SEVERIN KS 9827 Mode D'emploi page 14

Masquer les pouces Voir aussi pour KS 9827:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
of 4 mm, the freezer compartment must be de-frosted. It should be cleaned at least twice a
year as described below.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are:
- caused by the electrical motor within the compressor
assembly; during compressor start-up the sound level will be
slightly higher for a limited period of time.
- caused by the cooling agent flowing through the circuit.
The following table lists possible malfunctions and their probable causes and solutions. In
the event of operational problems, check first whether a solution can be found using this
table. If the problem persists, disconnect the appliance from the mains power and contact
our Customer Service Department.
Problem
The appliance is not working at all.
The normal operating sound changes or
becomes louder.
Transporting the appliance
The unit must only be transported in its vertical position.
Do not tilt it any more than 45°. During transport, ensure that the unit is properly secured
and protected against shock, vibration and shifting.
Disposal
This appliance has been manufactured from recyclable materials. After removing the
plug from the wall socket, the unit should be rendered unusable by cutting off the
power cord before disposing of it through special waste collection points in
accordance with local regulations. The refrigerant and the chemical agent in the insulation
foam must be disposed of through a competent agency. Take special care not to damage the
Possible cause and solution
- There is a power failure
- The main fuse has blown.
- The temperature control is set to '1'.
- The fuse in the wall socket (if
applicable) has blown. This can be
checked by connecting another
electrical device to the socket and
checking for function.
- Check for proper positioning (uneven
floor?).
- Are any adjacent objects affected by
the running of the cooling unit (i.e.
causing them to vibrate?)
- Are there any objects on top of the unit
which might be vibrating?
14

Publicité

loading