Ecler Nuo5 Manuel Utilisateur page 28

ECHO REVERB (10)
HP Filter:
Controls the High Pass filter placed in the Echo Feedback. This feedback
High Pass filter allows you for example to avoid possible "Bass" rumble
effect when played on large P.A. systems.
LP Filter:
Controls the Low Pass filter placed in the Echo Feedback.
Diffusion:
This control simulates the "diffusion" of the reverberated sounds: a small
diffusion will recreate a room where the walls are very flat (sounds are bounced straight, not diffused).
Density:
Simulates the density of the reverberation room (objects, people etc ...).
Decay:
Decay adjusts the "Reverb Time", the time it takes for the reverb to die off.
FILTERED ECHO (11)
HP Filter:
Controls the High Pass filter placed in the Echo Feedback. This feedback
High Pass filter allows you for example to avoid possible "Bass" rumble
effect when played on large P.A. systems.
LP Filter:
Controls the Low Pass filter placed in the Echo Feedback.
Feedback:
Gives more or less feedback to your Echo. The amount of feedback will increase delayed reflections.
Filter BP:
You can modificate the Band Pass filter aspect adjusting the Slope (how "sharp" the filter) and Resonance (cut-off
gain) specifications.
ECHO FLANGER (12)
HP Filter:
Controls the effect output High Pass. This High Pass filter allows you for
example to avoid possible "Bass" rumble effect when played on large P.A.
systems.
LP Filter:
Controls the effect output Low Pass.
Echo Feedback:
Gives more or less feedback to your Echo. The amount of feedback will
increase delayed reflections.
Flanger feedback:
Controls the flanged delay feedback %.
28